An Idiots guide to the Line Marking machine

(Download the document for a detailed guide to the machine)

• Ensure the battery is fully charged
• To check the battery, connect the red crocodile clip under the bonnet to the battery’s + terminal. The LED display on the top of the machine will indicate remaining battery power. Remember to disconnect after testing.
• Ensure the Basket Filter is clean and in position
• Fill tank with required level of water and then add paint (Always put water in first)
• Ratio of paint to water is roughly 1 part paint to 3 or 4 parts water.
• Ensure Paint/Water tap is on paint
• To circulate paint open Flow Control Tap (lever placed parallel to pipework) and switch Pump on. Switch Pump off when mixing complete.
• Screw lid down securely.
• To begin marking, close Flow Control Tap (lever at 90 degrees to pipework ) switch Pump on, and walk forward at required marking speed.
• After Marking, ensure the Clean Water Tank at the rear is filled with clean water.
• Flush the system through by switching the Paint/Water tap to water, then run the Pump for at least 20 seconds until clean water is sprayed from the nozzle.
• If the Flow Control valve was used, purge the return pipe by opening Flow Control
• Clean the tank, drain paint via the Drain Plug on the side of the Tank Body.
• Always rinse out the Basket Filter.
• Re-Charge the battery

For maintenance of the machine or re orders of paint contact :-
Nev Gibson or Brian Copeman